[[ImgSrc-search]]
Contact Us
Contact: Louise Liu
Tel: +86-21-51917600
Mobile: +8618221083910
Email: sales09@hanruipuzer.com
Website: www.hanrui-puzer.com
Home > News > Content
Conveyors Commissioning Procedures And Technical Parameters
Jul 13, 2017

The commissioning steps of the conveyors

First, the equipment installed after careful commissioning conveyors to meet the pattern requirements.

Second, the reducer, moving parts filled with the corresponding lubricants.

Third, the installation of the conveyors to meet the requirements of a single device after the manual test, combined with commissioning conveyors to meet the requirements of the action.

Fourth, commission the electrical parts of the conveyors. Including the regulation of conventional electrical wiring and action, the equipment has good performance, to achieve the design function and status.

First, the transport capacity: Conveyors capacity is the unit of time to transport the amount of material. In the transport of bulk material, the quality of the material delivered per hour or volume calculation; in the delivery of pieces of goods, the number of pieces per hour to calculate.

Second, the component size: Conveyors component size, including conveyors belt width, slab width, hopper volume, pipe diameter and container size. These component sizes directly affect the conveyors capacity of the conveyors.

Third, the transmission speed: to improve the transmission speed can improve the transmission capacity. When the conveyors belt is used as a traction member and the conveying length is large, the conveying speed is gradually increased. However, high-speed operation of the belt conveyors should pay attention to vibration, noise and start, brake and other issues. For conveyors with chains as traction parts, the conveying speed should not be too large to prevent the increase of the dynamic load. At the same time the operation of the conveyors, the transmission speed should be determined according to the production process requirements.

Fourth, the transmission length and inclination: the length of the transmission line and the size of the dip directly affect the total resistance of the conveyors and the required power.

The main parameters are generally determined according to the requirements of the material handling system, the various conditions of the material handling site, the relevant production process and the characteristics of the material.