Contact Us
Contact: Louise Liu
Tel: +86-21-51917600
Mobile: +8618221083910
Home > News > Content
Belt Conveyors Tear Protection Equipment
Oct 20, 2017

This equipment is installed in the tape conveyors in front of the material point of about 1 meter before the use of the first tape conveyors to observe the normal work with the tape when the non-working surface of the tape, and then tear the tape to detect the installation of equipment to leave the normal belt Position 3 ~ 5mm or so, and adjust the balance block to ensure that under normal circumstances the detection equipment does not occur deflection. After which it can be put into use in the conventional access control program.

The main features of this protection device are simple and practical. Check the tape torn equipment from the tape near the non-working surface, tape if the tearing incident, even if there is no spill, but the tear on both sides of the tape will appear superimposed, tearing edge than normal tape sinking, it is This point of the sinking of the tape to drive the tape to detect the tape tearing the equipment deflection, so as to obtain the tape tear signal, access control program to immediately stop the operation of the tape conveyors to prevent further expansion of tear.

Belt Conveyors Definitions

Belt conveyors are a friction-driven machine that delivers material in a continuous manner. Mainly by the rack, conveyors belt, roller, roller, tension equipment, transmission equipment and other components. It can be material in a certain transmission line, from the initial feeding point to the final discharge point between the formation of a material transport process. It can be carried out fragile material delivery, can also be carried into pieces of goods delivery. In addition to pure material delivery, but also with the industrial production process in the technical process to meet the requirements of the formation of a rhythm of the pipeline operation line.

Tape conveyors, also known as belt conveyors, conveyors belt according to the principle of friction and movement, suitable for conveying bulk density less than 1.67 / ton / cubic meter, easy to extract the powder, granular, small pieces of low-cut materials and Bags, such as coal, gravel, sand, cement, fertilizer, food and so on. Tape conveyors can be used in the ambient temperature range of -20 ℃ to +40 ℃, sent to the material temperature is less than 60 ℃. The captain and installation form can be determined according to user requirements, the drive can be used drum, can also be used with the drive frame drive equipment.